Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I’m new to Duo, and I’m testing Client VPN + MFA authentication with Duo for the first time.The setup is:AnyConnect → Meraki MX → Duo Authentication Proxy → Active DirectoryI’ve tested everything, and it works fine. I’ve also synced the Active Dir...
Hi all,I have set up an MG53 cellular gateway connected to the WAN2 interface of my MX67. The MG53 provides the MX with a DHCP-assigned private IP address.However, I noticed that even though the MX receives a private IP from the MG53, it also appears...
Hi,
I’ve just noticed that the Meraki Community is currently in read-only mode, so I’m posting my issue here as I’ve already opened a support case.
I have two MS switches in my DMZ (dmz-1 and dmz-2). The issue started after connecting a second ISP ro...
Hi all,at Cisco Live 2026, I learned that buying Secure Access - DNS Defense licenses includes a no-cost trial of up to 100 seats of Secure Private Access (SPA). Cisco calls it an "extended" or "long-term" trial, but what's the actual duration?Im pla...
Hi,I would like to authenticate:external suppliersconnecting via Cisco Secure Client (AnyConnect)authenticating against Entra IDusing Access Manager as the NAC solutionIn short, the idea is the following:using the existing AnyConnect client, users co...
Hi James,my SIM ip should be static. For what i understand. i should change the MG from Routed mode to Passthrough so the public IP goes to the MX (not anymore via STUN).. SO at this point with a MX with a static IP public i can configure the Port-fo...
Hi Mark,yesterday when i had the problem, i asked for logs but there were any. We didnt debug but when i perform a wireshark capture on the interfaces connected to both ISP, i could see the multicast 224.0.0.2 port 1985 arriving from both routers.
Router is ok,configuration is ok and then im not in charge on those router unfortunately but im pretty sure the issue is the multicast setting in Meraki although i dont get whats precisely.
