Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have just purchased a number of the 2960s model switches. I have one 'odd-ball' version of the switches out right now, it is WS-C2960S-48TS-S. It can't get it to sync the archive. No other device is having problems. The error states to check th...
I have three different types of AP's going to a Cisco 4402, running 6.1.196.AP-1252AG are running fine.AP-1242AG are having very high errors in the outbound side.AP-1131AG are also having problems.This is an example of the switch's output. GigabitEth...
My console shows that I have 51 of the 96 devices are out-of-sync. I have am running up to date IOS, but it does not seem to be tied to firmware version or to model. Many have the "VLAN:Running" is shown in the events. When I run a sync job, it st...
Hello, I am having an issue that started very recently. We are seeing errors in the inventory starting this afternoon. Error received is from failed job is:RICS0001:Internal Error,unable to process the collected data from the device.The Inventor...
The switch is up and running properly (seemingly so anyway). I discovered the problem later when I was looking at LMS and noticed there was a unit that was not collecting its config. I updated the software to it and that did not help. (see version...
All you need to do is typeR507>enableR507#config tR507(config)#interface vlan 1R507(config-int)#no shutdownR507(config-int)#exitR507(config)#exitR507#write memThe interface for VLAN1 is turned off.
