Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello folks-Let's say I have VLANs 100, 200. And I want to route between these 2 VLANs.VLAN 100 - Default Gateway 100.100.100.1/24 - MAC address - MAC100VLAN 200 - Default Gateway 200.200.200.1/24 - MAC address - MAC200 Host on VLAN-A = 100.100.100.1...
Hi all-Our use case is a L3 leaf spine fabric running eBGP within the fabric. (No VxLAN at this point). My question is regarding edge routing. We have a rack dedicated for external connectivity. And external routing protocol is eBGP. In that context,...
hi All-I'm trying to understand and compare the following two eBGP leaf-spine data center setup:1. Each leaf and spine is assigned a unique ASN, and each spine has each leaf as a neighbor and vice versa.2. There is a single ASN for the spine layer an...
Thanks Joseph. What is the difference between an IRB interface and an SVI interface? I believe the “interface vlan <vlan-Id>” is an SVI interface. Thanks for your time.
Thanks Georg. That is very helpful.One related question. For the leaf ASN assignment, if we have leafs that are MCLAG peers, should they share the same ASN?Thanks!
