Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have been seaching the community for a while but I cannot see an answer.
I have a DMVPN network in deployment two of the spoke are behind NAT. They are connecting perfectly and OSPF is forming adjacenies.
The odd thing I noticed was when I t...
Hi,I have a callmanager lab running 8.6.2.22900-9 I have 2 physical IP phones connected, registered and are happy. I also have one CIPC which is also happily connecting to callmanager.On the physical phones (7970 and 7911) on pressing the directories...
Hello,I have been working on an issue for a while and I have managed to track down the issue, but I am not sure how to fix the issue.I have a ASA 5505 running 8.4(7) with a tunneled anyconnect vpn for inbound remote users. I also would like to setup ...
Hi there,I am running CME on a 2801 router. I have configured a dial peer that allows the analogue phone to dial and be dialed. When I call an IP phone from the analogue phone the IP Phone rings with an external ring rather than an internal ring. Is ...
Hi there, I have done quite a lot of searching on this and I don't think it will actually work but I would rather ask the question than spend the next 3 days trying to make it work.I have a Cisco 1841 router that I am trying to connect using a site-t...
In case anybody has the same issue. I manged to fix this. First the transformation set needs to be mode transportcrypto ipsec transform-set DMVPN esp-aes esp-sha-hmac mode transportAfter that the connection was still going via the hub but I noticed ...
After checking the DNS on the voice vlan and being correct I restored the phones to factory default and it seemed to resolve the issue. I had done that before may go and figure out what was differnet from this time when I defaulted the phone.Thanks f...
Hi JouniForss,thanks for the quick reply. Looking good, I never thought to put it at the top I was configuring it as a network object nat rule. Looks like VPN users can still see internal servers too!Thanks
