Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i get the error message "Interface Ethernet3/5 has been quarantined due to Cmd Failure" when i try to activate the System Uplink ports on the Nexus 1000v VSM. The symptom occurs under 4.2.1.SV1.4 (has been fresh setup, did before tests with 4.0...
Hi,i want to realize the following setup:- Central Site 871 with Internet Connection and static IP- Home office 871 with Internet Connection and static IP. On that home office router, there should be 2 Vlans: 1 for the office work and one for the use...
Hi there,we've got a problem with setting up an etherchannel between a Cisco Switch (built-in in a IBM Bladecenter) and a Alcatel OS7700. More specific, we do not have a problem to set it up - by verifying the channel status on both sides everything ...
Hi,i'm trying to set up a VPN/IPSec connection between two 857 routers. Both sides have a DSL connection and the issue is, that both sides gets dynamic IP Addresses.Is it possible to get a VPN Connection work in that case? Afaik the dynamic crypto ma...
Hi.Does anyone knows a document, where i can find the different switching performance (process switching, fast switching, CEF) for the Cisco 2621.I only found, that the "maximum throughput" is 25kpps when using fast-switching. But nothing mentioned a...
Sean,thank you !"show accounting log" helped me - i had the command spanning-tree port type edge trunk in the config which i somehow didn't realize that we hadn't this command in the 4.0.4 lab setup...so it was a copy/paste error (i copied the port-p...
Hi again.thanks so far for the hint with the dynamic keyword.But we now have the problem, that whenever the IP address of one side changes, the vpn does not come up properly. We have always to remove the "set peer xyz.dyndns.org dynamic" statement in...
Hi,you have to configure the "dynamic" keyword in the crypto map after the dns-name of the remote peer.Example:set peer myname.dyndns.org dynamicBUT:we have currently a problem with the dyndns updates and the cryptop map. Maybe it is a problem, becau...
I don't know exactly how your WoL works, but maybe it is a broadcast to the destination network.Try to create an ACL with the IP of the PC which wants to wake up your PC behind the router, and configure on the LAN Interface to which the PC belongs th...
