Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What are the technical differences between the TLS Proxy actions "No Decrypt" and "Pass Through" in Cisco SDWAN? Attached the screenshot below. There has been very little to no explanation in the docs and hope to get better elaboration here.
Hi, I am running a test scenario as described below to bring up 6PE, connecting 2 IPV6 islands over a MPLS core.All routers run the same IOS (Dynamips)PE1#sh verCisco IOS Software, 7200 Software (C7200-SPSERVICESK9-M), Version 15.0(1)M, RELEASE SOFTW...
Hi,I am currently setting up a LACP port-channel on the Cisco 6509 (SUP720-3BXL with the following modules:NAME: "6", DESCR: "WS-X6348-RJ-45 48 port 10/100 mb RJ45 Rev. 6.1"PID: WS-X6348-RJ-45 , VID: , SN: XXXXXXXXXXXNAME: "7", DESCR: "WS-X6548...
Hi,I am having issue understanding after a read on the route-map continue clause works based on Cisco's explanation.http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gt_brmcs.html#wp1045836There are two behaviors that can occur when the ...
Hi, If your vManage and vSmart devices do not have access to the internet, the alternative for vEdges to talk to them will be through reverse-proxy. This configuration can be found in Administration --> Settings screen. If configured properly, it wil...
Hi, Is the interface being configured as a last-resort-circuit? If the interface is configured as last-resort, it will not come up as long as any other WAN interface is active.
Hi,The error message you're getting seems to signal that you're trying to configure interface eth0 in both VPN0 and VPN512. That is not an acceptable configuration because a layer 3 interface can only be placed in one VPN. Running config doesn't look...
Hi, Is this installation done from ESXI or KVM? Importing the vManage OVA initially will be configured with a 20GB disk for vManage system usage. Subsequently a 100GB disk should then be created for database. As for your case, you may need to review ...
Before version 20.1, the maximum number of SLA classes was 4. With 20.1 release, the maximum number of SLA classes that can be applied to the vSmart controller is increased to 8. Link to 20.1 release notes (See "What's New for Cisco SD-WAN Release 20...
