Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi dears i do some exersices in packetracer im a bit puzzeled, for example for Huawei switches there is a command to create a banch of vlans at once like : vlan vlan batch 2 to 9 10 and etc and a command like : trunk port allow vlan 2,5,7-20 and etc ...
HelloPlease forgive me may be rather stupid question but could some one show me how to navigate through cisco web site to the page whre i can find different configuration examples.Let me explain , if for example i google PPPoE cisco config examle the...
hi friens i have a question there is s imple topology PE1 <------->P<------->PE2on both PEs i configured vrf vrf_alet us use PE2 as an exaplPE2(config-vrf)#do show ip rou vrf vrf_aGateway of last resort is not set33.0.0.0/32 is subnetted, 1 subnets...
Hi dears i was trying to bult OPtion A lab and faced a problem i saw it was discussed in this forum to be frank i folowed the suggestions about ospf vrf light capabilities but still have some troubles may be someone can tell mw what is wrong the netw...
hellothere is a simple topology TE tunnels 10 and 14 are build to betwean IOU 10 and IOU14 interface Tunnel10ip unnumbered Loopback0tunnel mode mpls traffic-engtunnel destination 14.14.14.14tunnel mpls traffic-eng forwarding-adjacencytunnel mpls traf...
thank you for your reply yes it works could you please also check my comments i dont undertand the logic why both of the prefixes are advertised into BGP and PE1 subsequently even after i deleted export-target from vrf thanks
hello thank youyes it worksi have few questionsafter i did the config you reccomended i filetered out 44.44.44.44/32 means it was not imported into the vrf on PE1 that is oki checked on PE2PE2(config)#do show ip bgp vpnv4 all neighbors 1.1.1.1 advert...
hi thanks a lot i found the doccument convering redistribution process of ospf into bgp https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/5242-bgp-ospf-redis.html thanks a lot .
hi , sorry for my late replyyes you were right it work , could you explain a bit in details what is the reasonand what does this comand do ?thanks a lot )
Hello PeterThank you for your reply.You are defenetly right about Autorute shortcat, and it works as you said.But as i remember for example if we usr GRE tunnel betwean two nodes we can form ospf or eigrp adjacency over GRE tunnel just in the same wa...
