Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need help to clarify if Cisco ACS 4.2 does support remote agent on Win server 2008 core enterprise 64-bit?? if not supported; is there any work-around solution for this?
I have a scenario to configure VPN IP sec tunnels between Cisco 3640 router and Nortel device, can any body help on this? Is their any compatibility issues between Cisco and Nortel?
I have a 3845 router with two BRI interfaces, and one CCM 5.0(4) and I need to configure MGCP between them, I'm not able to get the getway regestered!here is the router conf:isdn switch-type basic-net3voice-card 0 no dspfarm!voice service voip allow...
Hi; I have a problem in integrating unity express (AIM) 2.3.1 installed in 3845 router with 12.4XY1 release, with CCM 5.0(4) server, what is the recommended gateway to be running between the CCM & the router? I tried SIP trunk with no use and H.323 ...
We have a problem in regestering our CCM 5.0 and the 3845 voice GW router, the CCM shows the router as unregestered with the IP Address, and the router I noticed that I'm not able to show the MGCP endpoints. please how can I verify or point to the pr...
So it's not supported.As a work around solution; can I install the agent on a separate 2008 server standard and join this server to the domain. in this scenario the agent server can communicate between the ACS and the core 2008 Active directory serve...
Just to clear the recording issue; so the CCX can operate as a call recorder without the need for a 3rd party system?? what about its specification on how much calls and/or disadvantages rather than using a 3rd party one.thanks in advance
