Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have 2 WAN connections and we are sending voice traffic to ISP-A and data traffic to ISP-B with the use of an ACL to specify source IP subnet then a route map to specify a next-hop address. What I need to accomplish now is dual failover ...
We need to port forward group of outside IPs to an inside server and want to do this with as few commands as possible. I have it working with some static port forwarding command but want to know if I can consolidate these commands into fewer command...
Hello, We will be upgrading our network to include an additional 7206 router this weekend and would like to get some advice on some of the design with BGP. Currently we have one router with 2 BGP sessions and we will be taking one BGP session of...
I am creating a route map to enable us to specify the direction of outoing traffic on our router with 2 BGP sessions to our providers. Basically I want to direct our voice traffic out provider A and the rest of our traffic out provider B. Our voice...
Summary of the issue is that we replaced a customer's T1 with a circuit with 2 bonded T1s and there were multiple issues encountered. Webpages would only partially load, users reported slower internet performance, and multiple POP3 download issues. ...
I have created the route map with the default route, however packets are still taking the BGP routes that are in the system. What is the best way to override the BGP routes so that packets will take the route specified in the default route and route...
The return path is provided by advertising the prefixes to the 2 providers.I was also thinking instead about putting a route map on the outgoing interface of the voice provider, matching the voice, setting something like IP precedence to 5, then maki...
Jon:The only issue with falling back to the routing table is that there are routes to both providers in the routing table if the traffic does not match the ACL. We want *all* traffic to go to B if it is not matched in the route map for provider A. ...
Here you go...Voce_BSI02#show int S0/2/0Serial0/2/0 is up, line protocol is up Hardware is GT96K with integrated T1 CSU/DSU Description: 360 Order# 601738 MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxloa...
