About ripwinder

ripwinder · 04-26-2011

Hi all,We have a small DSL network. We inter-connect in to our partners L2 network via a 1Gb fiber that terminates on to the SFP port of our 3560, this is then connected to a router that provides PPPoE. All worked fine until we went to do a swap out ...

ripwinder · 01-20-2011

Hi All,We recently launched a new network connecting in to a DSL network. Basic set-up is that we have a Cisco 3560 switch with IP transit on one of the Gig ports and and then the interconnect in to the other Gig port. The customer traffic is deliver...

ripwinder · 09-29-2010

Hi,We have just taken a rack in a datacentre in order to host a 3560 switch. When we arrived today we found 2x 48v MCB (mini circuit breaker) on a DIN rail. We were not prepared for this and expected to see standard AC plug sockets. (We are based in ...

ripwinder · 09-18-2010

Hi All,I am trying to configure a 3650 provide DHCP on routed port and once its pushed out an IP address allow users on to the internet. Issue is I get an IP address when connecting to fa0/2 but cannot get out on to the internet, neither can I ping t...

ripwinder · 04-27-2011

Hi Yanil,I'm doing great thanks.Interesting, I just looked at the config of the 3560 and it shows the Gb ports native VLAN as 2 which is an unused VLAN. All traffic comes in on VLAN 30. I configured the new 2960 switch with native VLAN as 30 on the G...

ripwinder · 09-29-2010

Hi Ashley,From looking at the install guide it looks as though we would need to order a different power module but I cant seem to find the correct one to replace the AC module with DC.Cheers,RW

ripwinder · 09-19-2010

I am creating a service provider network on a smallish scale over a region. We are trying to start small and then scale up later once we get to a few hundred users, hence the 3560. All traffic is deliverd to us from customers in one Vlan so we need t...

ripwinder · 09-19-2010

Thats great. Thanks so much for your help. I'm not sure if this is your area but I am now looking at using 802.1q to use qinq on Vlan2. If I use qinq does the user actualy have to configure anything on their PC/CPE or does the 3560 just automatically...

ripwinder · 09-19-2010

Ah OK I see, thanks. When I deploy this in to the live environment we will have Vlan1 with IP address given to us from the tier 1 transit provider with their default gateway address. All IP addresses we provide via DHCP in Vlan2 will be public IP add...

Member Since	‎09-15-2010 05:53 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	19

User Statistics

User Activity

PPPoE Issue on 2960GS

RDP Issue on DSL Network

3560 48V DC?

Routed port (DHCP) to Wan issue

Re: PPPoE Issue on 2960GS

Re: 3560 48V DC?

Re: Routed port (DHCP) to Wan issue

Re: Routed port (DHCP) to Wan issue

Re: Routed port (DHCP) to Wan issue