Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just configured AP 1830 via firmware mobility express via the GUI and it worked. But after restarting the system, the device still broadcasts the default SSID "CiscoAirProvision" and the SSID that I made, so also I can't get into AP management.How ...
I just bought a Cisco Aironet 1830 with the AIR-AP1832I-F-K9 model. when I will configure the GUI but the SSID not broadcast defaults to the "CiscoAirProvision" broadcast so that I cannot do this configuration.is there anything that can help so that ...
I just configured wlc 3504 on the side of vlan10, and I have several different AP1830 vlans that will be controlled by wlc. but when I connect AP1830 with the interface vlan in each manage switch, unfortunately WLC does not detect any AP joining.for ...
i just bought a WLC 3504 device, after completion at the process setup wizard. then i can't enter the web based controller stage, with ip management that i have set. how can i enter this section.? for the switch i have set it to trunk mode
No. This is a new device, and I did a conversion from Firmware lightweight (Capwap) to Mobility Express.for successful conversion results until I do the configuration. but after restarting, there are two SSIDs, and I can't get into device management.
I have tried by placing the AP on the same subnet but still not detected.even though if the PC is connected to a certain switchport vlan it immediately gets DHCP, and can ping WLC ip and can also open the GUIis there another way to do something like ...
