cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5328
Views
5
Helpful
5
Replies

WLC 3504 can't connected on web based controller after setup wizard

Reedho
Level 1
Level 1

i just bought a WLC 3504 device, after completion at the process setup wizard. then i can't enter the web based controller stage, with ip management that i have set. 

how can i enter this section.? for the switch i have set it to trunk mode

 

 

1 Accepted Solution

Accepted Solutions

If you set a vlan for management interface in initial setting make sure it is not the native vlan on that trunk port.

 

with that you should be able to ping/GUI access the wlc.

 

HTH

Rasika

View solution in original post

5 Replies 5

If you set a vlan for management interface in initial setting make sure it is not the native vlan on that trunk port.

 

with that you should be able to ping/GUI access the wlc.

 

HTH

Rasika

I have successfully trunk the port, and can ping but still can't access the GUI, is there something wrong with my setup wizard?

Console into the wlc and make sure you can ping the gateway from the appliance. You are also trying https correct.
-Scott
*** Please rate helpful posts ***

Did you try https://192.168.10.10 ?

 

If not try that

 

HTH

Rasika

Solved

by changing the native vlan according to the existing trunk vlan and access https://ip address

Thanks @Rasika Nayanajith

Review Cisco Networking for a $25 gift card