Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am seeing this in a show ip route vrf XXXX output.Googling I find no explanation or obvious reading material though many hits to other outputs with same thing.What does it mean?Much appreciate any reply...
GreetingsI can get on to the APIC with provided credentials but these same credentials do not work for vSphere access.I can get to the prompt so it looks like it is up.No credentails are visible to me as per screenshot below.Greatly appreciate any he...
Is there any way to backup a lab setup and then restore that setup in a new lab booking at later time?From Viptela SD-WAN perspective it is not clear to be how the system might be backup up/restored.I have found a CLI command to backup the NMS databa...
I have connected successfully to the SD-WAN sandbox to the point where I can SSH to one of the Viptela boxes (See (2) in screenshot) and am prompted for the username/password.But I cannot find what those credentials are.I tried devnetuser/Cisco123! w...
How would I get to fab4leaf3 in your example?From the APIC CLI I was expecting to see an attach command but I only see an attach-avs commandShould I SSH directly to the leaf?
Zowu - thank you. I have the access that I needSummary:Ubuntu host Putty - WorkingAPIC - (Was always) Working. Credentials in the Lab overview tab posted aboveRDP working to 10.10.10.99. vSphere is open on the machine. Repeat - I am good and thankyou...
Hi ZowuThank you so much for replying.I am assuming I should have found that PDF will go back later and see if I can locate it for next time.I still have a problem however with vSphere credentials are not working as advertised.Also notice the vSphere...
