About slctest123

slctest123 · 04-27-2011

Hello all. I'm configuring a 2921 Router. It has 3 GigE ports, of which I'm using 2. I would like the router to also act as a Gateway system between the 2 networks. Can you tell me which configuration commands I need to accomplish this?Thanks in ...

slctest123 · 04-25-2011

Greetings all. I'm new to the CISCO community and need help with configuring a VWIC2-1MFT-T1/E1 card on a 2921 router in my lab. I've followed the configuration steps for the card, but when I run the sh controller command, it shows 'down'. My conf...

slctest123 · 04-28-2011

Reza:Thank you for your response. I have already performed those steps, but was concerned that there were additional commands (gateway, forward, route, etc) that may be required.Thanks again,--Roland

slctest123 · 04-25-2011

Thank you for your response. Yes, I did have a T1 connected. My problem was that I needed a cross-over cable between our lab's T1 cable and the router. --Roland

Member Since	‎04-23-2011 12:05 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	4
Total Helpful Votes Received	5

User Statistics

User Activity

Newbie: How can I configure a 2921 as a Gateway system?

Problem configuring VWIC2-1MFT-T1/E1 on 2921 Router

Re: Newbie: How can I configure a 2921 as a Gateway system?

Re: Problem configuring VWIC2-1MFT-T1/E1 on 2921 Router