Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Gurus, I need some help on how I can perform this.I have problem in figuring out how to apply the IP SLA tracking to bring a direct interface connect down.My diagram will be like this 10.20.200.1/26 ...
Hey Guys, I would like to ask for advise from the community.I recently detect that there has been some SSH attempts on our server and would like to identify the culprit IP address.I decided to go with the SPAN configuration and put a laptop with wire...
Hi Guys, I am trying to configure vxlan configuration on the GNS3 and found out issues between the ASA and Nexus.I noticed that this flapping only occur when I introduced the nve interface into the configuration on Nexus.Prior to this (configuration ...
Hi,I have a mixture of ASA5506-x, 5515-x and 5525-x in my environment.The 5506-x firepower version is limited to 6.2.3.16.There ASA5515-x and 5525-x can go up to 6.4.x version.All these devices are currently managed by a centralized FMC and I would l...
Hi,I have successfully set up VXLAN configuration in GNS3 and its working fine.Even with HSRP, its working fine.However, this is not what I would like to do.I have 2 DC, namely PROD and DR.On each DC, there are 2 Nexus 9k switches with VPC enabled.I ...
Hi Nikolay, Editing my reply as I was wrong... Looking at this page (URL: Solved: Webex Room Kit mini and Webex Codec plus will not update - Cisco Community), it is possible to use the cop file to upgrade the webex (thank you to @Roger Kallberg for p...
Hi Paul/MHM, This has nothing to do with default route.The route that I am concern with is 10.20.200.0/26.Attached is the topology, if there is a break in connectivity between the switches (represented by the red arrow), the interface that is connect...
Hi MHM Cisco World, PBR will be a valid solution if there was a next hop in the equation.However, traffic between us and the 3rd Party contractor will reside in the 10.20.200.0/26 ip address range.His FW (10.20.200.3 IP) will assume the IP address of...
Hi Paul, Dont think the static routes will work because a directly connected routes will always win (AD of 0).The interface on the ASA is of 10.20.200.1/26.Traffic towards the 3rd party contractor (within 10.20.200.0/26 ip ranges) will always be goin...
Hi Deepak,I will give this a shot and let you know how it goes.I did have a read in the forum that says that in context mode, some of the commands that you listed is not working.But I will give it a try.Thanks.
