Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following topology set on AWS where there are 4 CSR 1000v Routers deployed and Segment Routing enabled in which the Segment Routing Headend is R1 and the destination is R3. I aim to send perf traffic from Endpoint1(Client) to Endpoint2 (Se...
I have the following topology , where there are 4 Cisco Routers deployed in each AWS VPC. I am able to ping and generate traffic from Endpoint1:172.0.1.11 to Endpoint2:172.2.1.10 where the traffic passes through a set of paths called Segment Routing...
I have a setup of Cisco CSR 1000v routers. I established a GRE tunnel between 2 routers, where the tunnel's source is the GigabitEthernet1 interface.I aim to measure the load on that GRE tunnel. The load value can be calculated as the following:Load ...
I'm trying to deploy `SR-TE` on `XRv9000` routers `IOS XR 6.3.1 version` which are deployed in AWS according to the topology below.I have accomplished the configuration of `SR` on all routers which are based on the official tutorial Cisco's official ...
Thanks for the reply Kumar, ip-172-0-1-8#Show policy-map police
Policy Map police
Class class-default
police cir 10000000 bc 312500
conform-action transmit
exceed-action drop Even after sending 6501kbps traffic, I got some d...
Thank you for this content. I'm really interested to build SR a scenario on AWS using XRv9000 routers, but the images are not shown. Could you please update the links?
