Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am experiencing an issue which relates to twice NAT. 2 environments are set up with same subnet IDs. Now requirements is to let host is Environment A needs to talk to host in Environment B.Real Source (x.x.x.x) and destinations (x.x.x.x) IP's are b...
We have 2 VTP Domain working in our network. We are in process to migrate 1 of VTP Server mode from Cisco 6505 to Cisco Nexus 5596(currently Client of C6505) being new Core switches. All switches have their equivalnet peer (i.e C6505 with C6505, N559...
Hi All,I am looking for help in production scenario of Cisco Nexus 5000 Series switches hanging as peer and connected to other nexus, 6500 pairs in etherchannel config.Just read the best practices from cisco and found there shouldn't be "spanning-tre...
We have 2 different circuits running between same cities. Circuit 1 is dedicated to use Stream Box video streming traffic. We have applied access list at our Router to route traffic appropriately.Main issue we observe is that, Packets are not matchin...
Hi mate,
how did you fix the issue. I am having the same issue with Status light keep flashing after reload.
Before reload, only Active Light was turned Amber, and yes console just shows the message :
"Booting system, please wait..."
What you are asking me to do it use to Source Egress interface IP scheme (4.4.4.0/24) as source. Which I couldn't understand properly. However, I did try as below, still getting same response on capturing the traffic.nat (Test_Env,Eng_Test) source dy...
Yes this statement is pretty much correct."1.1.1.0/24 NAT static NAT for individual IP’s to 10.1.1.0/24"Usually Hosts from Env B talk to other subnets and areas. Which is covered through NAT (one-to one) like;Env B:ip 1.1.1.1 Nat to 10.1.1.1 1.1.1.2 ...
Salaam Bro Rizwan,I have made similar kinda nat config as mentioned in my attached layout. Except the last bit, where you are using the same mapped destination instead of real destination (1.1.1.20) as prescribed in syntax. Could you please re-affirm...
Googday,I have kinda issues with NAT as well. I am experiencing an issue which relates to twice NAT. 2 environments are set up with same Subnet IDs. Now requirement is to let host in Environment A needs to talk to host in Environment B.Real Source (x...
