Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We trying to do videoconferencing from a Polycom box through the internet to another polycom box. The boxes use H232 and H239 for the video conferencing and the content streaming.Setup: At our site we have the internet coming into a DMZ switch that...
I'd like to setup a split default route on a 2800 series router so that packets that source from one network (lets say 10.1.0.0/24) are routed to one gateway but packets from another network (lets say 10.2.0.0/24) are routed to a different gateway.Wh...
I'd like to intercept packets from my Cisco IP Phone 7912 series to my PC (plugged into the phone's PC port). What do I have to do in order to capture the phone's output at a packet level?Thanks. -Scott
I've been banging my head against a desk all day over this one... and I know its gotta be something I just overlooked... I'm trying to set up a LAN-to-LAN connection between these two devices using pre-shared keys.IKE = goodIPSec tunnel = online.IP ...
Yup. Basically activate the NAT on the polycom unit. Ensure the public address is correct. The main "silver bullet" is on the cisco device. Issue the following commands at a (config)# prompt:no ip nat service H225no ip nat service rasIf I recall ...
Note, my goal at the moment is to have it work the way it's suppose to so right now I'm just trying to open any and all ports and then I'm going to harden it later.Note, this config works with version 12.4-9.T6 with all but the H.239 stuff (the H.232...
Sorry about that. Didn't see all the posts listed yet. Okay, so the 7912 has no "leaky packet" option? We run pretty much all CE500 switches here with one 3560 in the middle of the topography. Can I set a span up like that on a CE500 (no CLI...)....
