Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm lookin to change the endpoint DSCP marking for signaling from AF31 to CS3 on the 6608 module. Does anyone know how this can be done on the actual gateway itself or through CallManager? I've verified the CCM Enterprise Parameter for Call Signali...
Kaine,Yes technically this can be done. This would use the IP to IP GW feature or the legacy MCM feature. Essentially IP to IP gateway allows for Voip to VoIP routing, where as a traditional H323 GW does VoIP to POTS. If you would like a detail de...
Ahmed,Of course the Cisco Gatekeeper implementation Jeff recommended does have a more scaleable CAC then CallManager locations and is the preferred method for complex configurations. The problem with the CCM CAC, is that the Location is just a singl...
Kevin,A couple of things. One I don't see anything out of the norm with your configuration. Of course we do need some show commands to get a better feel. Since it's MGCP, you defintely want to make sure the link to CCM is clean for Backhaul. Even...
Kevin,Please post your configuration if possible and a 'show controllers t1 x/x'. Also is this to CCM? Is it using MGCP? The more information we have the better we will be able to assist you.Please rate any helpful postsThanksFred
John,How many DIDs do you have? The reason I ask is it might be better to explictly set the few DIDs you have with a translation-profile then all remaining non-DIDs with a final statement in the translation-profile with the generic number.Here is an...
