About regu1

regu1 · 02-23-2019

Hi everybody I have integrated an ISR 4331 with FXS ports connected to CUCM 11.5 via SIP .The issue i am facing is When i make an call from CUCM endpoint to the FXS extension i am not getting ringback tone in CUCM end ,but the FXS extension is ringin...

regu1 · 02-20-2019

Hi Everybody I am new to this Cisco voice architecture and in need of basic config steps/guide to configure isr4331 as an voice gateway for connecting analog extensions in the FXS card.The Isr 4331 will be connected to CUCM 11.5.I am confused on the ...

regu1 · 03-07-2019

Hi Shankar Saw your post .Iam planning to install CMS and integrate with CUCM. Please do share if you have any guide on the same .Its kind of confusing on the requirements for CMS installation like Does CMS and CUCM needs to be in domain for both of ...

regu1 · 02-23-2019

The ISR 4331 config which has the issue MCIT-VGW-1#show runBuilding configuration... Current configuration : 5556 bytes!! Last configuration change at 11:06:13 utc Sat Feb 23 2019 by mcitadmin! NVRAM config last updated at 10:17:02 utc Sat Feb 23 201...

regu1 · 02-20-2019

Hi Thanks for the Link ,It would be helpfull to get some guide specific to my requirement in configuring the ISR 4331 with CUCM to connect FXS ports.

Member Since	‎02-02-2019 07:50 AM
Date Last Visited	‎12-11-2019 08:08 PM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

CUCM to FXS port connected via SIP one way audio path and no ring back tone

configuration guide for CUCM to ISR4331 for FXS analog extensions

Re: CMS Integration with CUCM, for ad-hoc conf

Re: CUCM to FXS port connected via SIP one way audio path and no ring back tone

Re: configuration guide for CUCM to ISR4331 for FXS analog extensions