Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,How can i install a license in this version, i have the .lic file that cisco send me to install it but in this IOS XE version i cant.normally i use the command:license install flash:license-file.lic1/1 licenses were successfully installed0/1 licen...
hi, Im having problems passing traffic with mtu above 1500 and df activated through l2vpn connection. this is the configuration on both sides: 36X-PE1# sh run int vlan1617interface Vlan1617description PE1mtu 1600ip address 10.169.84.2 255.255.255.248...
Thanks for the respond, i will check if there is a policy in the path.Its ping to an ONT from a Cisco ASR9906. The ONT its connected to a BNG and in the PPPoE session has the policy. The BNG is a juniper MX204.
Thanks for the info, As you said, ping with mtu about 1500 pass when you do it from another equipment. ping with the SVI where you configure the xconnect does not.
