Hi, Community,
I am still at learning stage, highly appreciate if someone help me in static routing. My static routing in packet tracer is not working with attached topology. The Router_1 does not shows any static routes though I've configured and sa...
Hi Experts,I would like to check, would it be possible for us to connect 2 ISPs(Point-Point or WAN) to CISCO 2960-X for 2 systems?. Attached sample network diagram. Please advise.Much appreciated in advance.Regards,draj
Dear Community Experts,As I am new to networking, seeking your valuable advice to clarify some doubts in networking. The scenario, current setup that we have in our local site 3 VOIP communication systems, and the requirement was I have to move one o...
Hi Experts,Newbies seeking specialists advise, I am having catalyst 2960-X series switch and it's been configured to bring one up-link via ISP to the remote site. Is it possible to configure for 2nd up-link through another ISP vendor for next remote ...
Hi to all,
I am trying to configuring cisco catalyst switch 3850, everything is fine except encapsulation dot1q. when i tried to configure encapsulation no command available to proceed further to config dot1q. any one can advise me is that command av...
Hi,In PT, this thing happened if missed the "dns-server" command in router configuration when the IP dhcp pool enabled to obtain IPs and we need to tell the router while creating the DHCP pool what is our dns server. you may add it later but if do so...
Hi,Much appreciated for help and the time invested for me. Static routing is working now with default route :). Can I take a chance to clear my doubt on VLANs over the WAN(internet) with same topology, would it be possible to bring over multiple VLAN...
Hi, Deepak Kumar,Thank you for the clarification.This is to achieve the client at B-end should be able to receive automatic voice broadcast messages from the A-end thru the ISP1 or vice-versa and the needs of the ISP2 to receive the data signal from ...
Thank you for your reply.I believe the WAN speed would be 10mbps since the system required around 6mbps.I am not sure about the budget details, it might be the cheapest one, please.Thank you
