Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After much unsuccessful searching, I wanted to share my findings on getting Cisco Flexible NetFlow (FNF) data to work with PRTG Network Monitor, specifically using a Cisco Catalyst 3850 running IOS XE Gibraltar 16.12.13 and PRTG version 25.4.114.1032...
Hello I have just upgraded the ASA to 9.14(4)24 and ASDM 7.22(1). No issues or drama. However, it coming clear the MD5 hash is out of Sync between ASDM and the ASA and this is impacting the ASDM's ability to show the Top 120 Access Rules in the main ...
Hello All Struggling with this one hence looking for some help. I'm looking to allow Internet access to my Teens VLAN32 during an active time range which I have setup. However on the ACL seems to work in the opposite way. It shuts down Internet durin...
Hello... Looking for some insight/help on my config. I have a NAT setup as a NetworkObject, so there is no STATIC route from inside to outside... How do I setup a second NAT NetworkObject and the associated SLA/Monitoring, that I would need to priori...
Worked out the problem. by trial and error.... tried the usual stuff (rolled back the ASDM, then put it back to 7.22(1)) removed all the ACE (rules) in the ACL for the Inside interface. removed all the SSL certs and recreated, no luck. However when i...
sorted... I needed a second ACL to deny all so traffic allowed during the active time range... (for VLAN20) and deny any.... i guess the packets are checked and if they meet the 1st line it stops, and allow the traffic (permit). If the packet fails t...
Hi... I’m sure you need to set a admin password, I also created a new user from the console and enabled asdm acesss via interfaces.. so you might want to setup the basic inside and outside interfaces via console.I think this part is key to getting th...
Thank you for the input, this is most appreciated. Would i be correct in my understanding, if the addtional static route includes a distance of 200. Its ignored until DHCP client route track 1 fails with a distance of 1 and "DHCP client route" is a f...
