Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Need quick help with the below issue - Unable to monitor current traffic using logging monitor via ASDM Device - ASA 5525IOS - 9.4(4)5ASDM - 7.8(2) Please advise Best regards M.
Hi All, i have cisco catalyst 9200, a stack of 5, which reboots every often. please see below in the output for the changes to the link OK its 8 and 6. could that be a possibility for the reboot and why is that different any advise please? Sw#/Port#...
Hi all,
I have a site to site vpn with aws, and i have restricted all the inbound traffic using an acl explicitly by denying any any(for both ip and icmp). still users from aws can access my network and can also rdp in, and also ping my network
Y...
Hi all,
in two different scenarios
1. if there is a layer 2 switch in between two routers
2. if the 2 routers are directly connected
in both the cases the ARP is only showing the MAC address of the router interface, HOW CAN I FIND OUT remotely?,...
Hi all,
ASDM: packet tracer: link "show rule in access rules table" doesn't work but only for inside rules and works fine for all other access-group access-rules
Not sure if this is a bug but, If it was a bug should have affected overall?
Best ...
Hi, @Leo Laohoo Please see below the information for CRASHINFO SW1#dir crashinfo-1:Directory of crashinfo:/11 -rw- 0 Jan 1 1970 00:00:56 +00:00 koops.dat36641 drwx 32768 Mar 11 2020 15:24:13 +00:00 tracelogs30 -rw- 25699930 Nov 6 2019 23:15:57 +00:0...
Hi @Leo Laohoo Please see below WIN-3FL-SW1#dir crashinfo-1%Error opening flash:/crashinfo-1 (No such file or directory)WIN-3FL-SW1#dir crashinfo-2%Error opening flash:/crashinfo-2 (No such file or directory)
@Leo Laohoo did run the command but found not output WIN-3FL-SW1#sh platform software mount switch 1 R0 | i ^tmpfs.*tmp | e /tmp/WIN-3FL-SW1# any other output you think @balaji.bandi thanks