Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have configured my BNG with two radius servers in one aaa group :
radius server rad-01 address ipv4 10.10.4.20 auth-port 18012 acct-port 18013 timeout 10 retransmit 3 automate-tester username dummy ignore-acct-port probe-on key *****
radius s...
Hello, I've 7201-NPE-G2 running as a BRAS. currently all my accouting data is calulate using accouting information that I recieve from BRAS.I have a Server farm and I want to have per-user accouting infomarion for all traffic from/to my server farm.A...
Hi, I'm traying to implement dynamic authorization and Per-User QoS.What I have already done is that I can send rate-limit interface command via Radius AVpairs and it works.Now what I want to do is that I want to change rate-limit without disconnecti...
hi .i have a pix 515e(7.2) and now running l2tp/ipsec remote access vpn and connect to it via Microsoft vpn client.I've configured that all of my users using just one pre-shared key , default tuunel-group and default group-policy so , all of my users...
hello everyone,i want to configure pix firewall to hide my servers real ip address from the internet , so i use static translation .now i configured my pix firewall (7.2) to do that with this configuration :static (inside,outside) xx.xx.8.45 192.168....
Hi,
I have faced with this issue before. Its because of a change in default PPP Packet throttle value in this version.
My problem solved after I have increased Throttle threshold:
ppp packet throttle 20 1 30
Note:
As far as I noticed, this is the ...
Dear Manuel, Thanks for your reply and sorry for being late in updateing this post. - I haven't started to use ISG as I didn't have a clear Idea about ISG services.- I've read about ISG recently and now I'm familiar with it.- I'm going to setup ISG f...
Hi , Have you configured your asdm image location and authorization?-----asdm image disk0:/asdm-647.binhttp server enablehttp X.X.X.X 255.255.255.0 ----Regards,Nasser
I've solved the problem by setting password for scheme sheer to cisco ! - Enter the Oracle sid: MCDB - Enter the Oracle admin username: system - Enter the Oracle admin password: ******** - Enter the password for the scheme sheer: cisco - Enter...
