Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello heros, dtp is disabled by "switchport nonego" but still i see
Sep 19 21:16:37.541: %DTP-5-NONTRUNKPORTON: Port Gi3/0/23 has become non-trunkSep 19 21:16:38.027: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet3/0/23, changed st...
hello, my router running isr4300-universalk9.17.03.03.SPA.bin, not showing the config file although configured to do so. its 3d after reboot.
33356111>show configurationUsing 20511 out of 33554432 bytes33356111>
33356111#sh run | i priv
...privilege ...
hello, any ideas why ibgp default route is preferred over the ebgp one? AD should elect the ebgp route. primaryRouter#sh ip b 0.0.0.0BGP routing table entry for 0.0.0.0/0, version 29954754Paths: (2 available, best #1, table default, not advertised t...
hi, can i stop those out of service modules from appearing ..alarming due traps sent to my monitoring system?
blah#show platfoChassis type: ISR4331/K9Slot Type State Insert time (ago)--------- ------------------- --------------------- -------------...
these occasions first thing after no luck with the clearing the vty line is reboot. that probably already happened...? and suppose it fixed the problem.?
thanks Mr. Georg, good point, definitely plenty of power is on the switch to be granted. there are just 4 APs on the C3850-48P, each takes like 15w and still >160w remaining.
ASW1#show power inline
Module Available Used Remaining(Watts) (Watts) (Wa...
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/esm/configuration/xe-16-6/esm-xe-16-6-book/log-local-nonvol.html
- Before logging messages are written to a file on the bootflash or harddisk, the Cisco software checks to see if there is sufficient d...
