Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,
I've recently deployed a HyperFlex 2.1 with the recommended setup (using different VLANs for all mgmt and data networks) which works perfectly fine. Customer is using some VMs on VLAN1 (I know it's not recommended and should be some other...
Hi all,
I searched online but couldn't find any official document for upgrading HyperFlex DP 2.1 to 2.6 version. Release notes provides some level of information but not the necessary steps about how to conduct upgrade entirely.
Anyone has acces...
Hello Community,
I currently integrated an Active Directory to newly deployed UCS Manager 2.2.6f and i had various different problems like bind user password standard, secure LDAP connection issues but solved all of it and finally succeed to authent...
Hi everyone, We have a 5108 Chassis which was working perfectly but last week our Fan Modules started to work with full speed without any specific fault or event message. When i check the Fan status from the UCSM everything seems "OK" but the fan sp...
Hi all,I'm trying to configure lun-based zoning on MDS 9124 Switch but i'm doing something wrong. If there is someone with experience about this any advice can be handle. I looked everywhere to find a configuration guide or example but didn't find an...
I'm uploading the stripped firmware packs to the emulator but I'm not able to see them as packages and when I go to firmware management, I'm not seeing them as available versions. I tried this with UCSPE 3.1.2 and 4.2 but they both are same. Any reco...
Hi Clifford, sorry for the late response but yes, as you said it's possible to use VLAN1 after the installation, it was another network issue that prevented VM to ping it's default gateway but now everything works perfectly fine. Thank you for the ex...
I found the whole bunch of documents explaining HyperFlex upgrade procedures.
https://www.cisco.com/c/en/us/support/hyperconverged-systems/hyperflex-hx-data-platform-software/products-installation-guides-list.html
Hi Kirk,
Thank you for the reply. I did all those tests and debugs many times and didn't have any problem at all but as i said sometimes fails and sometimes works. Mostly works today but i'm not sure it will remain that way. That's why i wanted to as...
