12-08-2012 03:41 PM
Hi all,
I'm trying to configure lun-based zoning on MDS 9124 Switch but i'm doing something wrong. If there is someone with experience about this any advice can be handle. I looked everywhere to find a configuration guide or example but didn't find anything about it.
thanks
12-09-2012 06:05 AM
Hi,
Can you post the commands and error error message?
Please be aware of this.
(not supported on gen4 linecards)
Do you have gen4 linecards in the fabric?
You will also need an Enterprise License
Also, lun zoning is not available in interop mode.
Last, after configuring a zone, place the zone in a zoneset and activate the zoneset.
Regards,
David
12-10-2012 11:45 PM
Hi David thank you for your reply.
First of all i'm using MDS 9124 with Enterprise License (grace period 118 days remains). I'm configuring zoning but when i try from server and scan the vHBAs to see LUNs. But server seing all LUNs attached.
I'll try couple of different things and post here tonight.
Burak
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: