Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have 2 ASR1001 and I'm trying to bring up a direct link between them.The SFP that I used is SFP-GE-T which is supported.ASRs are running the recommended IOS XE release 3.7.6S.The config of both interfaces is extremely simple:interface Gigab...
Hi all, I have the following configuration on a couple of Nexus 7K:N7K-1interface Vlan3 vrf member TEST ip address 10.139.7.252/22 ip pim sparse-mode ip pim dr-priority 100 ip pim hello-interval 5000 no shutdown N7K-2interface Vlan3 vrf member...
Hi all, I have the following configuration on a couple of Nexus 7K:N7K-1interface Vlan3 vrf member TEST ip address 10.139.7.252/22 ip pim sparse-mode ip pim dr-priority 100 ip pim hello-interval 5000 no shutdown N7K-2interface Vlan3 vrf member...
Hi all,I have a Nexus 7009 with 2 Supervisors SUP2E and NX-OS 6.1(4).After a system switchover between Supervisor multicast traffic is not forwarded for about 50 seconds and the output of 'show ip mroute' shows pending entries:Nexus7K# sh ip mroute v...
Hi all,I have a Catalyst 4507 with SUP7L-E running cat4500e-universalk9.SPA.03.03.00.SG.151-1.SG.bin.The network diagram is attached.I'm trying to transport PAgP over dot1q tunnel but PAgP packets are not carried from one site to the other on any dir...
Hi Leo,I used another SFP-GE-T with part number 30-1421-01 and it works fine.Anyway the SFPs with part number 30-1421-04 are not broken. I tested them on a Catalyst 3750 and they work fine.Maybe there is an incompatibility between ASR 1001 and SFP-GE...
Hi Leo, thanks for your support.I already tried to disable auto negotiation and specify speed and duplex settings.Now I'm going to check hardware revision of the SFP as you suggested. Stefano
