About japinder

japinder · 10-20-2019

Hi , For one of my project i want to configure a switch using C++ . is it possible ? My configuration requirement is to switch on and switch off one by one for each port :- Using command switchport On and then switchPort off ( at a time i wan...

japinder · 03-11-2019

Hi everyone , i am quite new . I have been stuck up from quite few days . i have to implement a solution for the below requirement . 1) i have 15 devices with same ip address ( ip address is hard coded inside and can not e changed ).2) each device...

japinder · 10-23-2019

No its not manufacturing fault. Consider buying an off the shelf module example a wago controller . They are preloaded with a defaukt ip . And There manual always come with a default IP in the manual and steps to change it . Also this is a customer ...

japinder · 10-21-2019

Thanks for the reply, By duplicate IP address devices . I mean , i have to implement a solution for a company which manufacture sensors . all the sensors have same IP address before packaging. before the sensor get packed it need to be tested with t...

japinder · 03-12-2019

Hi kasun... thanks for the help . I was also thinking to go with vrf . But i also not so good at it .Nat capable l3 switches arequite expensive . Any suggestion is there any switch which can do the natting

japinder · 03-11-2019

Hi ,The customer devices have same ip.What they want is to either recognise the device using the switch port to which it device is connected or to generate a maksing ip which can be used in place of device ip to connect to a device .2) The pc is on t...

Member Since	‎03-11-2019 12:06 AM
Date Last Visited	‎11-02-2019 09:58 AM
Posts	6

User Statistics

User Activity

Configuring a switch Using C++

connecting multiple devices with same ip address which can't be changed

Re: Configuring a switch Using C++

Re: Configuring a switch Using C++

Re: connecting multiple devices with same ip address which can't be changed

Re: connecting multiple devices with same ip address which can't be changed