Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,The router firmware is 1.0.03.15We've set up a few entries in the Multi Wan - Policy Binding TableHow can we change the priority for existing entries ? After updating the priority field, it switches back to the previous value...Than you !
Hi,
We've set up a IPSec Tunnel between 2 RV130W routers, with firmware 1.0.1.3
On each side, there is a PPoE connection, with dynamic public IP address. So each side of the tunnel is using a xxx.no-ip.info FQDN to find back it's counterpart.
So far ...
Hi,We replaced our SPA3102 with a SPA232D.FXO port is connected to our analog line, Internet port is connected to our LAN.The PSTN line on the SPA232D is registered with our Asterisk server so calls go through our analog line.From our IP phones to ou...
Hi,I need to setup a vpn tunnel between 2 sites.The first site (main site) is already using an RVS4000 and doesn't need any change.The second site (remote site) already has modem/router installed. This modem/router will not support many changes, as i...
Hi, I need to configure a rv120w in order to make it work at the same time for data and digital tv. The fact is that the set top box for the idtv needs an IP adress that will be delivered directly from the ISP. So I need to setup one LAN port that wi...
Hi Fotis,
We already use FQDN, as both ends have a dynamic WAN IP address. So we use DDNS FQDN addresses.The DDNS updates are working well, and the IP address changes only every 48 hours, so I think it's not related with the floating public IP as the...
