Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team, I have one ISR 4331 having only Lan two ports ..We are now in phase of SdWan implementation...I have two SD wan devices at site..But I would like to only one gateway for these two SD wan devices which is going to connect router... Option1:...
Hello , We seen the both FPR2110 becomes active-active suddenly.it was working fine in active-standby fail-over. we have used direct ethrenet cable for cross/sync link between to firewall. FPR2110 IS MANAGED BY fmc. Also seen the CPU utilization pri...
Dear Team, Is it possible to connect cisco catalyst switch with industrial Ethernet scalance x208 switch ? if yes then please let me know the configuration on catalyst switch of port where industrial Ethernet scalance x208 we can connect. Is it on a...
Hello , Getting below error & the ports of switch is not working but everything is working with master and having problem with member switch which is getting below error. please suggest if you have any solution ? Your responses are highly appreciated...
Hello, The HRSP not possible with our scenario as only one public IP available with us. Is it possible by using virtual interface(L3 on router) & then we can assign L2 vlan on each physical interface.
Dear Team,I have attached sample diagram.I know we can achieve this connectivity using Mini switch.I need your help on option 2 diagram.Actually i want to configure the single gateway on router & but dont want to use the mini switch in between the SD...
