08-18-2015 08:26 PM - edited 07-05-2021 03:48 AM
What is the login and password default for the Aironet 2702 model
Mat
08-18-2015 10:52 PM
Cisco/Cisco
08-18-2015 11:10 PM
Does not appear to work, just says access denied.
08-18-2015 11:29 PM
its a standalone AP or connected with controller ?
Regards
08-19-2015 12:04 AM
I want to configure it to standalone, but it comes as controller based. So I am wanting to get into it to do the config to switch it. Seems to be plenty of blog son how to do that. I went into it with PuTTY and when it challenges me for login password is where I am stuck. It is the AIR-CAP-2702I-Z-K9
08-19-2015 12:20 AM
then enable password must be "Cisco".
Try again.If still not work then paste the screenshot..
08-19-2015 12:24 AM
Still no, Cisco/Cisco
08-19-2015 12:31 AM
Hi,
Check this to reset it: https://popravak.wordpress.com/2014/08/26/resetting-cisco-capwaplwap-access-point-to-factory-defaults/
Regards
01-09-2020 01:14 AM
Hello,
If its connected to controller then is it possible to login the AP through CLI using ssh..?
01-09-2020 06:20 AM
08-19-2015 05:25 AM
A. Cisco IOS Software-based APs have a default configuration that includes a user name and password combination, both of which are Cisco (case sensitive). After you reset to factory defaults, be ready to give Cisco as both the username and password when either the GUI or the command-line interface (CLI) prompts you.
08-20-2015 03:34 PM
Default
Username : Cisco
Password: Cisco
08-14-2019 12:44 PM
if registered to the WLC, you can change the Credentials via WLC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide