Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I copied configuration from SUP1 and put it in SUP2 bootflash.When I use command set boot auto-config bootflash:sup.cfg, it gives me following message.Warning: file found but it is not a valid config fileAppreciate any suggestions.Thanks!!
I have a 2950 switch which is behind a Cisco PIX (7.0). While trying to telnet to 2950 the connection is intermittent. Sometimes telnet works and sometimes not(no login prompt). Below is the capture on PIX. 1: 04:42:16.747626 10.194.1.106.47552 > 10...
Can we place content engine outside interface on PIX DMZ interface. At this moment both the WCCP router and content Engine are on outside. I want to place Content Engine Outside interface on PIX DMZ and then to run WCCP between Content Engine and Out...
I am not sure if this is a place to ask this question. But after no luck i thought of posting it here to get an answer.I am using Content Engine 565 with ACNS. The CD accompanied with this product contains Smartfilter console and server. The document...
Has anyone tried using smartfilter 4.1 with ACNS 5.1 on content engine 565. ACNS 5.1 is running.SmartFilter API Version: 3.2.4SmartFilter Plugin Version: 3.2.1.00I tried using port no. 8001 and 8003. But smartfilter administration console shows "agen...
HiA device which is capable of transmitting traffic without slowing it down is said to work at wire-speed. That is that the processing by the device is not adding delay to normal trasmit speed.Switch Fabric interconnects the various components of the...
Hi Mohan,Enable debug isdn standard or debug isdn events with term mon.Then self dial your number. See if you get anything in the debug.or if you are able to dial ur own number.If you are able to self dial then try the same on the router on other end...
