Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My Catalayst 4507 is reaching up to 82% CPU utilization and I noticed that K2L2 Address Table R is causing the high CPU, kindly help me to resolve this issue.C4507#sh processes cpu | in HiPri|LoPri|CPU utilizationCPU utilization for five seconds: 82%...
I have WS-C6509-E with WS-X6708-10GE installed, i noticed that my asic-1 & 2 temperature is reaching to 65C. Can anyone give me some document what is the normal temparature for ASIC. module 8: module 8 power-output-fail: OK module 8 outlet tempe...
I tried to telnet my cellular interface but it didn't work. It showing refused by remote host. Need your help please.interface Cellular0/0/0 ip address 192.168.81.78 255.255.255.0 ip nat outside ip virtual-reassembly encapsulation ppp dialer in-band ...
After Implementing an autonomous AP 1200 series and making the basic configuration, I ran Aironet Desktop Utility from my laptop to see the signal strength, I noticed that SNR (Signal To Noise Ratio) was decreasing suddenly from 50 db to 12 db then a...
now it working now, What I did, I reassinged the ip address from cellular interface to the loopback interface. then configured the cellular interface as interface Cellular0/0/0 ip unnumbered Loopback0
Actually my main objective to have a remote access to the router. My problem is the service provider they allow only one ip address ( which is the ip address of the Cellular interface). The LAN IP address is NATted. This is located in the remote bran...
