Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 18 Cisco 140ac access points in one of my schools. I am having problems with some of the APs unjoining and then rejoining. When this happens, the unjoined AP shows as "Mesh Extender", then that goes away when it rejoins. I don't have Mesh E...
Good Day,I have just installed 18 new Cisco 140ac access points in one of my school networks. WIFI is working fine, devices are connecting and no issues there. Using the Management Web GUI, I can see all 18 APs, but sometimes they won't have the st...
Good Day,I set up ten Cisco 140AC (CBW140AC-A-CA) access points for one of my schools this week. I used the Cisco Business App to configure them (set up SSID, named each of the ten units AP01-AP10). I didn't set static IPs as I couldn't see that op...
Good Day,I have ten Cisco AIR-AP1832I-A-K9C units that I am setting up for one of my schools. I used the Cisco Mobility Express to configure the first unit as the Master and it is working fine. I plugged another unit into the same switch, it gets a...
UPDATE: I have all APs now running on the latest firmware, 10.10.1.0. This seems to have fixed the unjoining issue I have been having with some of the units. I tried to upgrade from 10.6 directly to 10.10, but it didn't work. The Preferred Primar...
Rich R, yes I don't see any notice on the release notes about having to do incremental upgrades. I will back up my configuration and try the 10.10 upgrade when I am at the school tomorrow. Thanks again for the response.I will post my results here a...
Rich R, thank you for your quick reply. Turns out I was trying to edit in the wrong area of the web gui, the Action button is where it should be (I haven't had to look at these APs for quite a while, and my brain failed me once again). I will upgr...
I am going to leave the static ip addresses as is for now, they all appear to be stable over the last 1.5 hours. I will plan on a future school visit to release my APs from their static prison and let them run free.Thanks to marce1000 and Scott Fell...
Scott,Thanks for the details about using DHCP. My method has always been static, but it is good to know that DHCP works just as well. I wouldn't bother with mac address reservations if the APs don't have to be set with a particular address all the ...
