Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys. Hope everyone is doing well in these crazy times. I attempted to set up a Router on a Stick setup via instructions on youtube. The instructor did so on packet tracer but I wanted to give it a go on my physical lab. Unfortunately, after comp...
Hey guys. I'm still in the early stages of this stuff. I have a Cisco 1841 router double NATing from my ISP router. My 1841 router is then connected to switch 1 via Fa0/1. Switch 1 is connected to switch 2 via Fa0/13 on both switches.I trunked it. So...
Hello. I'm still relatively new to this, so please forgive me if this is a dumb question. I tried googling this but cannot figure it out. I wanted to see debugging in action on my Cisco Router (1841) so I turned icmp debugging on. Then I used window...
Hey guys. I got some help setting up my home lab and getting my 1841 fully online. Now, when I ping www.google.com, I get a perfect response when I do it from command prompt on my host plugged in to my router. But when I ping the exact same thing fro...
Hello. I thought with the things I have learned at this point, that I could simply figure out how to connect my 1841 to my ISP router and from there, be able to plug a host in to the one free fast ethernet port on my router and reach the web. But thi...
Thank you! I think I forgot to do a no shutdown on a few of the switch interfaces. For some reason, I still can't ping to everything but when I recreated the ROAS in Packet Tracer, it worked perfectly and I could ping evertyhing from any VLAN. I migh...
Thank you, guys, for the responses. It's appreciated more than you know. Luis- I entered your suggested configuration but I still cannot reach the web from my host plugged into fe0/1. I can ping 8.8.8.8 without issue, but when I ping google.com, I ge...
Thank you, Seb. I think I finally figured out the problem. So every single time I would do the no shut command, it would ALWAYS spit out a "changed state to up" line follow immediately by a "changed state to down" line no matter what I tried. Finally...
