Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys I am finding it difficult to identity the root cause of the copy failure when trying to copy the image 17.3.4 from the TFTP Server to the Cisco 9500-48Y4C. Command used is : install add file tftp://10.10.10.10/cat9k_iosxe.17.03.04.SPA.bin I c...
Hi Guys. I need to upgrade the 4451 from 16.9.2 to 16.9.5. Humbly requesting for your advice on the steps. Currently on the show version, it readsSystem image file is "bootflash:isr4400-universalk9.16.09.02.SPA.bin"and show startup-config has only:bo...
Spoiler Hi Guys, We have the 3850-12XS-E in the Install Mode. I have few queries around it and will be very grateful for your assistance. 1. The Verify /md5 flash: cat3k_caa-universalk9.16.09.05.SPA.bin The md5 value match between Cisco.com and ...
Hi Guys We have this issue.When we chose IOS distribution to 8 switches, it just displays Yet to Start Operation. Then chose only one device for IOS distribution, it still displays Yet to Start Operation. Yesterday we managed to successfully distribu...
Hi Guys We need to change the MTU to 9192 on just one port on the 3850 Switch. The rest of the 11 ports will still be at 1500. Did some research and it's just stating System MTU which will change the MTU on all the ports. We cant change the System M...
Thanks Balaji The syntax used for the copy is : install add file tftp://10.10.10.10/cat9k_iosxe.17.03.04.SPA.bin This is a Stack switch. Currently running 16.12.03a I want to run the following command to activate and commit. 1. install activate auto-...
Hi Everyone Thanks a lot for your replies. Yes, I did make a mistake thinking that the copy process will be shown, example the !!!!!!! Using the install add file tftp://X.X.X.X/OS Name We are getting this alert. /usr/binos/conf/install_init.sh: fork...
Thanks Leo Have done that. And also noted that more flashboot:packages.conf | i .pkg has double entries. Are we still safe with it and config register value is at 0x2102. The output is as follows: Router#show run | in ^bootboot-start-markerboot syste...
Hi Leo Did steps 1 - 4. Please if you can check if it is safe for me to copy run start and reload. Router#$00-universalk9.16.09.05.SPA.bin overwrite verboseVerifying parametersExpanding superpackage bootflash:isr4400-universalk9.16.09.05.SPA.bin... p...
Thanks LeoNothing is listed. Router#more bootflash:packages.conf | i .pkgRouter# Should I just point it as follows just to be safe and go for the "Using Consolidated Package to boot" Router(config)#boot system flash bootflash:isr4400-universalk9.16.0...
