Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,You can check this troubleshooting guide, it has a detailed information on the message flow and debug messages to look,https://www.cisco.com/c/en/us/support/docs/voice/skinny-call-control-protocol-sccp/118646-technote-sccp-00.htmlHope this Help...
Hello,If I have understood correctly, your requirement is when calls come in from SIP provider to the number "12768008501", it should get translated to "666" on GW, get routed towards CUCM and the Hunt group members should ring.Can you make the below...
Hello,Great.Yes, that is correct to enable dsp services under voice-card. Usually, a reboot of the router is not required.Please mark this as Solved and also rate helpful posts.Thank you.- Rohan*** Please rate helpful posts ***
Hello, With your controller configuration as,controller E1 0/1/0pri-group timeslots 1-31!Enable DSP services under voice-card 0/1 as, voice-card 0/1dsp services dspfarmno watchdog!Check if the voice-port 0/1/0:15 is created and let us know. Hope this...
