Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just upgraded the switch code to 17.09.05 and the initial configuration dialog keeps popping up. This switch will be added to an existing stack so I don't want it to have a config. Is there any way to bypass this or do I just need to go through a...
I have an ASA 5525 and a Catalyst 9500 switch that have been exchanging routes using EIGRP for years. Last night that quit working. I will include the show eigrp events below.ASA/act# sh eigrp events Event information for AS 100: 1 23:49:10.074 P...
What would be the best way to setup a redundant tunnel on an ASA? Something with 2 crypto maps that go to the same IP?This would be for failover so if the primary is down the data is routed to the seconday?There would be to 2 different devices on th...
I have a Nexus 9300 switch that has my guest network on it. I do not want to route this network on the Nexus because of security reasons so I won't put an address on it. I will route the L3 traffic with my Cisco ASA.1. Will the switch forward the DH...
I have 2 ASA 5525's in a HA pair. I need to move them to a new switch. I am planning on moving all the interfaces of the standby FW then make sure failover is re-established. I will then failover to the standby and move the last of the interfaces....
Thanks for the help Reza. The config register was not set on that switch. That switch was right out of the box so not sure why. The newer code is different and the command is not the same as the older code.
Thanks for the reply. I don't know what could have prompted the poison to begin with. This has been working flawlessly for years. All of a sudden it started. I don't summarize my routes because I have never had a reason to in the past. I leave t...
