Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello AllI have created a Proxy for the Smart Lic and I am testing this on a 9200 Switch. I have enable the following command and waiting to see if they switch will send the Http request to the proxy server. Since this is the only device I have set...
Hello AllI have created a Proxy for the Smart Lic and I am testing this on a 9200 Switch. I have enable the following command and waiting to see if they switch will send the Http request to the proxy server. Since this is the only device I have set...
Hello I have an CIsco 220M4 bare Metal serverIt has 8 ( 1.8 TB ) Drives and when I created a new Virtual Driver Raid 0 with 4 TB drive I was not able to get it to boot. I am not able to get in the Cimc since the Version want to use FLash which was r...
Hello AllI have a tetration device we are going to Decomm. I would like to know how I can wipe out all the Drives to DOD standard. If there is a way I can clean this up without pulling the drives and connecting to an external server and doing it th...
Hello AllI am working on a LAB/Pilot to Create a Ipsec tunnel to vendor over bgp using the Tunnel1 connection. I have create the tunnel and have the IPsec up and working. Examples are connection to Cloud connection but I want to hid my internal IP ...
Hello AllIf I want to run the http and https traffic via the proxy server ( Barracuda gateway 810) I do not see this traffic hit the barracuda at all. I would like to know what I need to set. I have the following command config on this device.!! co...
Hello AllI was able to update the CIMC code to 4.1.x version and I am able to get into the app. this being said I still am not able to make the VD bootable to support Booting in UEFI Mode with drive with 4K sector. it still gives me the error about U...
Hello AllI would like to know how I can access CIMC via the url. I took the CIMC from 2.10e to 3.0 and update to 4.1.2f. I was understanding that once I get to 4.1.2f I would have access to the CIMC via the https://x.x.x.x and that would allow me to...
Hello AllI have been working with this issue and I enter the following to enable UEFI boot. ref to below. I have a 1.8TB drive that I created the Virtual Drive from and it is 4k so this should work. used the BiosConfig for the controller to create ...
Hello All I was looking on the web and I see the LSI version but I do not have LSI webBios so It looks the same as the AVAGO version. I wonder if they are all the same but just the name change. I try to see if these steps work for making the drive...
