Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello There,I am looking to downgrade a couple of Catalyst 9500 switches to 16.12.x from 17.x. Switches are running in the bundled mode. As of my understanding, in the bundled mode, you just need to change the boot variable to upgrade or downgrade. M...
Hello,I was wondering what will happen, if the dedicated DUAL ACTIVE link in a SVL setup fails? Would there be any disruption, in terms of traffic? Or in terms of SSO states? I see documentation about SVL links failure. However, I can't seem to find ...
Hello,I tried to look but I couldn't find any detailed information about Nexus 9300's MACSEC abilities. I am looking for information such as, MACSEC speed (line rate or not), supported on all the ports or not etc. Datasheet doesn't say much. If anyo...
Hello There,Although I am under the impression that catalyst 9K series doesn't support FLEX link, if someone knows otherwise, please correct me. Also, if my impression is correct, is there any alternate for FLEX link on Cat 9Ks? Or RSTP is the way to...
Thanks guys, for replying. "No boot system" did the trick. I was trying to use the command with the image name that it was pointing to but it didn't like it. Mysterious ways of the "Cisco World". Thanks again. Stay well. Best,TT
Thanks for your responses, guys. I replied last night through an email but, somehow, it didnt get posted. Anywho, in our case, latency is the time takes to switch a frame from one port to another on the same switch. As Joseph mentioned, nowadays, in ...
Thats fine, Paul. I am in the same boat. Your assumption is spot on. Its a typical Access and Collapsed core design. Fast L2 convergence is the objective. Read a white paper and it seems, REP has sub-second convergence times. To be specific, 50-250 m...
