Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,I am in need of replacing 2x Nexus 3548 with another 2x same Nexus 3548 switches. I tried to to it by swapping the first new switch with existing master which both have the same configuration but could not succeed. After some time the whole net...
Hi Guys,As you see the below configuration, I want to be able to access a device (192.168.1.100) using port 7331 and 7332 from outside the network using the external ip address and port 7331 and 7332. But when I tried to check the port status usin...
Dear Team,I am facing issue after upgrading WS-C2960X-24PD-L switch. The old image was c2960x-universalk9-mz.152-2.E5.bin. The issue started after upgraded to c2960x-universalk9-mz.152-4.E7.bin. Switch is accepting the new image but not working prope...
Hi Friends,I am in need to upgrade Cisco WS-C4507R+E with Dual Supervisor engine cards to the latest available firmware. Current firmware is as follows.cat4500e-universalk9.SPA.03.02.00.SG.150-2.SG.bin,1;ROMMON software version is :3 fc99.471e.e280 t...
Hi All,I am planning to upgrade Cisco WLC 5508 which is currently having Software version 7.5.103.1 and Field recovery software version 7.6.95.16. Latest available software for this device is 8.0.152.0 (AIR-CT5500-K9-8-0-152-0.aes).Is it recommended ...
Dear Paul, Thank you for getting back to me.I have corrected the config. What will happen if the host 192.168.1.30 not open to those ports or down. It this case if i try port scanner will it only shows port 7331 and 7332 "closed."?
Hi Paul,Actually the attachment was wrong. The router doesn't reside behind another router. Kindly find the attached current config.what do I have to do to open port 7331 and 7332.
