Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am facing issue in my Cisco ACE L7 server load balance policy . there are two policy for total 4 server (2 for each) one load balance policy is working and second is showing down state . i have checked all the configuration and it is similar to...
Hi , I am facing issue in cisco ACE Server Loadbalancing . We have configured policy-map for server loadbalancing but it is not working . VIP state was showing OUTOFSERVICE and LB Action state was showing DOWN. Kindly check the below logs and att...
Hi, I have replaced the new SUP720 card in chassis c6509 but it was going to rommon mode again and again after selecting the right image . Kindly find the below error messages . *** System received a Software forced crash ***signal= 0x17, code= 0x24,...
Hi, We have a two different hsrp configured router on a network but it showing active on both the device and continuesly getting fluctuate . What was the reason ???
Hi, I have facing a bugs on my current device-ws-c3850-48t which is current working on software version-03.06.03E so please help me out for a stable version for upgradation.
Hi Luis, Both the devices are in same network also they are able to reached successfully without any issue . we have check the virtual gateway it is also the same . still we are getting continous fluctuation in HSRP logs and showing active & Unknown ...
Hi Balaji Bandi , Both the devices are able to reached successfully without any packet drop and the group number is also same on both the devices still they are showing Active Known in Show Standby Output.
Hi, This is to inform you that following bug errors are getting continuously so please help me out between 03.06.06E & 03.07.X : %SNMP-3-CPUHOG: Processing GetBulk of bsnMobileStationPortNumber: %SYS-3-CPUHOG: Task is running for (2510)msecs, more t...
Hi , I have read the article but in my senario my primary is failed and secondary become active so I have to replaced new one in current live setup without affecting the secondary-active configuration.so what is the best way to complete this task.
