Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Is it possible to exclude a Cisco endpoint from registering via TMS without deleting it from TMS?For example, we run a statewide government video conference network, over 1500 endpoints, we recently updated endpoint software to patch a securit...
Hi all, I have an installation where we are wanting to use a Cisco Air-AP2802I on a mobile trolley to provide network to a Telehealth device. Because we use the POE input/output to power the telehealth device, can POE for the AP be obtained via the A...
Thank you all for your replies. I thought that would be the answer, but it never hurts to check as I have learned some tricks off this support channel.
Hi John,2802i WAP has 1 x POE Port, 1 x AUX Port , 1 x Console Port and a USB connection.The POE port is used to connect to the medical device, this is how the medical device gets its network connection. The medical device plugs into a medical cart t...
You enter the reset_config and y commands after the line of code that says “press ctrl+c within 5 seconds to stop boot” The device will continue to boot, but will eventually catch up to the command you entered and action it. Once the device has gone...
