Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm utilizing the 4 GigabitEthernet ports of the Cisco 8200 router, two for LAN (LACP active mode), two for WAN (LACP active mode and I NAT between the two. I'm using IOS XE 17.09.07.Port-channel1 is the LAN and uses interfaces GigabitEthernet0/0/0 a...
According to this, I should be able to utilize the cellular interface's GPS as an ntp refclock but the refclock command is missing completely.I'm running 17.09.07b IOS-XE on a Cisco 8200L with P-5GS6-GL. The cellular controller config is:controller C...
I would like to use the IOS-XE DNS server on a router to act as a Internet DNS forwarder where it would forward DNS requests to name servers both in the cache and negotiated from DHCP and IPCP on outside Internet-facing interfaces. Currently, this wo...
The documentation states that unencrypted throughput is unthrottled and encrypted throughput is controlled by license. What does encrypted throughput mean in terms of the 8200 throughput license restriction? I've read the documentation and I'm still ...
I have three WANs; one is the primary and the other two are backups. Primary = dhcp; Secondary = Cellular0/2/0; Tertiary = Dialer1The routes are as follows:ip route 0.0.0.0 0.0.0.0 dhcpip route 0.0.0.0 0.0.0.0 Cellular 0/2/0 251ip route 0.0.0.0 0.0.0...
Hi Guiseppe,What other load balancing options are there to use in IOS-XE running on a router (not a switch, because switch load balancing options are different)? The only load balancing options are available on this IOS are flow based and "vlan-manua...
Hi Joseph,As I mentioned before in my pervious posts, the cable modem connected directly to the workstation using link aggregation on both ends (without the 8200 or switches in between) resulted in the correct measured throughput (~1300Mbit downstrea...
I forgot to mention, the network diagram is simple (modem <-> 8200 <-> workstation) with the following:Port-channel1 is the LAN and uses interfaces GigabitEthernet0/0/0 and GigabitEthernet0/0/1.Port-channel2 is the WAN and uses interfaces GigabitEthe...
During a multithreaded test, I ran show platform hardware qfp active interface if-name Port-channel2 statisticsPlatform Handle 18
----------------------------------------------------------------
Receive Stats Packets ...
Hi Giuseppe,How can I check this? According to the activity LEDs on both the cable modem and workstation, it appears there is activity on both with the same flash rate during these multithreaded tests, but despite this, test results still show ~945Mb...
