emuman100
Level 1
Level 1
Member since ‎05-11-2019
‎06-24-2024

User Statistics

  • 59 Posts
  • 0 Solutions
  • 8 Helpful votes Given
  • 1 Helpful votes Received
Recent Badges
40 Discussion Posts
40 Replies
5 Discussion Posts
50 Discussion Posts
30 Replies
30 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts

User Activity

Has anyone been able to figure out exactly how to use the NMEA streaming over IP option using the NIM-LTEA-EA on an ISR4000? I cannot figure it out at all. The configuration here says you specify a source IP, destination IP, and port:lte gps nmea {ip...
I have three WANs; one is the primary and the other two are backups. Primary = dhcp; Secondary = Cellular0/2/0; Tertiary = Dialer1The routes are as follows:ip route 0.0.0.0 0.0.0.0 dhcpip route 0.0.0.0 0.0.0.0 Cellular 0/2/0 251ip route 0.0.0.0 0.0.0...
I'm having an issue where my ADSL dialer interface is not coming up despite the VDSL controller is trained using Verizon ADSL in the Eastern US. Here is Verizon's pertinent configurartion: VPI:0 VCI:35 Encapsulation: LLC PPPoE username/password: X.X....
I'm looking to add another 9120 to connect to my my 9120 running EWC. It seemed to join the EWC and it shows up as an online AP, but it shows as standby, like it's another standby EWC. It also looks as if it has both the AP and the EWC image.I was lo...
I had a 2702E that a 9120AXE replaced. The 2702 was running in autonomous mode and compared to the 9120AXE with EWC, it seems to have a little less of a footprint than the 2702E with the same antennas and bands and being in the same exact location.I ...
Community Statistics
Member Since ‎05-11-2019 09:46 AM
Date Last Visited ‎06-24-2024 10:46 PM
Posts 59
Total Helpful Votes Received 1
Helpful Votes From
Helpful Votes Given To