Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there anyway to get the Cisco CB21AG adapter running either under the ADU or the XP Zero config to interrupt the XP Ginas so it doesn’t try to contact anything on the network before the user logs in? In this particular setup the customer does NOT ...
Hi,I've just logged a TAC case on this one, but has anybody seen lower than expected dbm levels when just testing 1310 bridges in a lab? I've got them a few feet apart connected to the injectors with the short white f type cables. They're running 12....
I'm hoping that someone can give me a quick answer to this (easy if you've done it) one.In the event that ALL devices configured as WDSes on a network fail, will the APs that are configured to talk to the WDSes, failover and authenticate clients dire...
I just had a few problems with the same error. It turned out that this was an issue with the client device NEEDING the key to be entered in HEX (even though it would take an ASCII if you typed it). I converted the ASCII PSK I'd configured on the cont...
I've just posted in another thread about this, but I'm seeing a very similar issue (not exactly the same though).The APs in this case are 1200 series IOS upgraded running 802.11b interfaces only. There are multiple SSIDs NONE of which are broadcastin...
I'm seeing a similar issue with the 3945 right now. However in my example the following is the case;APs are 1200 series IOS upgraded running 802.11b interfaces only. There are multiple SSIDs NONE of which are broadcasting.We've got a few different cl...
1. What model of AP are you using (I ask because you mention a console port)?2. How were you trying to manipulate the AP to point at your other controller after removing the group?An LWAPP AP does "remember" some config parameters. Rather than factor...
You might want to post carrier busy test results for both ends as well as signal strength readings for both ends. If memory serves you'll need commands like (check my syntax):dot11 dot11 0 carrier busy (assuming 802.11g)andshow dot11 ass X.X.X (X.X.X...
