Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Installed the cuci moc add-in for my OCS R2 client but when trying to connect it fails.The server status notification popup shows the following message:Unknown Error.[DeviceAdaptorInitiazationFailed] Invalid CCMCIP authentication server configuration...
Currently I have configured my Rightfax server by using dial-peers on my h323 gateway pointing to the destination IP of the rightfax server.I would like to use only the dial-peer which points to our callmanager and use the callmanager to redirect fax...
Telco only sends last 2 digits as called party number.These 2 digits represents the extension number and not the main-number.I also expected to see (parts of) the main-number of the ISDN-2 box.I need to create a route-pattern on our callmanager to ma...
I am using a VPN Cisco1710 environment.After a while I am not able to access this device thrussh anymore. Message: "Unable to open connection: Connection refused"After a reboot it is possible again.IOS: 12.2(15)T5Any thoughts ??
Issue has been resolved.I downloaded the latest version of the cuci-moc software which only included the software.The previous version 7.1.2.zip also included a cucimoc-Admin-ffr.7-1-2.zip, which has the Administration Toolkit.This toolkit also inclu...
Hello Michael,thank you for pointing me into the right direction. The document is very helpfull and noticed that I had to do some more configuration.That said, I went thru the instructions and checked the registry entries for the CSF but I cannot fin...
Thanks for the tip, indeed I was able to resolve this issue by using the correct translation pattern on the callmanager.It's indeed a H323 gateway connected to an ISDN BRI.Thxerwvan
