Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone, We're having trouble troubleshooting the site to site with Fortinet and ASA. Our firewall is ASA ASA5525.Few days ago we observed that the tunnel very often to went down, even we refreshed the tunnel it won't bring up.And we need to ini...
Hi Everyone,Just want to know what are the traffic passing in vPC peerlink? and what the behavior of the traffic of orphan ports, they will pass through peer link ?Regards,Ronnie Billate
Hi All,The server are running in orphan ports and connected into two CSW1 and CSW2, anyone can comment on this design?For sample rtr that configured in vpc sometimes the router can see the 10.62.192.10 and cannot reach the 10.62.192.11. vice versa b...
One router, Two Outside, One Inside, Two Outside public NAT in One inside IP.Any can help me, I trying to have a network with - 1 router- 2 ISPs- two OUTSIDE- one Inside- all servers publicly have two NAT PUBLIC ISP.What I did is I configure IPsla, i...
I have check the ACL both ends were the same.The life is the below right ?crypto ikev1 policy 1authentication pre-shareencryption aes-256hash shagroup 5lifetime 86400how can i see the idle time?
Hi Bb, The server side was config as active active as per the administrator, i tried to config it as po and vpc the link didnt went up. I think because the server is not in lacp config. 1. In network side what is the right and simple configuration? ...
